Pentair INTELLIPOOL AUTOMATION Guía De Instalación Y Usuario página 29

Indoor display
The Indoor remote display informs all parameters (updated every 15 minutes) of the water and air temperature.
Intended for indoor use, pre-programmed alerts allow a quick glance to check the chemical balance of water without the analysis tedious at the
poolside.
Moving the display can cause signal loss. If there is more than 1 hour out of reach, all information is erased.
The remote display can be used put on a tripod or wall mounted (after testing the signal range)
1 : Air temperature (° C or ° F)
3 : Pool cover rolled
5 : Operating without heat
7 : Sand filter alert
9 : IntelliFlo alert
®
11 : Alarm Mode
13 : Radio mode
15 : OFF the alarm
17 : IntelliChlor alert
®
19 : Clean filter required
21 : Radio relay batteries level
23 : Value of ORP in mV
25 : Self-adaptive unit (g / l) or (µS)
27 : Tick for a correct value
29 : Spot litght ON
31 : Risk of snow
1
2
3
4
5
6
7
9
10
11
12
13
14 15
16
17 19 20
calib on alarm
2 : Water temperature (° C or ° F)
4 : Heating alert
6 : Heating running
8 : N/A
10 : IntelliFlo running
®
12 : Calibration Mode
14 : The alarm ON
16 : IntelliFlo alert
®
18 : N/A
20 : Indoor display batteries level
22 : Radio force signal
24 : Value of the rate of salt (g / l) or conductivity (ĩS)
26 : pH value
28 : Water temperature alert (<+3°C)
30 : Pool cover closed
32 : Temperature unit (° C or ° F).
32
31
alternative display water / air
30
29
1 = escape
- go back to previous stage without confirming modifications
2 = move down / decrease
28
- browse downward in scrolling menus or decrease values in numerical sections
27
3 = move up / increase
- browse upward in scrolling menus or increase values in numerical sections
4 = validate
26
- access the parameter displayed or validates modifications and goes back to the previous menu
25
24
23
21 22
1 2 3 4
27