Pentair INTELLIPOOL AUTOMATION Guía De Instalación Y Usuario página 31

Ice risk detection
The water freezing pictogram is displayed if the pool temperature is below +3°C (37.4°F). There is a risk of ice forming on
the surface; action must be taken to prevent damage to the pool. If filtration is connected, Control unit will automatically
launch the filtration. In case of technical room heated, +3°C set point can be changed in ControlCenter/Setting/Install/
Filtration menu.
Current mode
Alarm mode and Calibration mode correspond to the position of the switch on the back of the remote display. RADIO mode
means that the radio is programming a new element on the IntelliPool® network.
Activate / deactivate sound
On remote display, an audible alert for the different alarms and a discreet button beep are available. This pictogram illustrates
sound activation and deactivation, accessible via the switch on the back of remote display.
Batteries level
The level of the batteries is displayed under the pictogram representing each element.
The service life of the batteries is over 1 year, but may vary according to climate conditions.
> As soon as the level reaches "Batteries very low", the batteries should be changed: (Radio relay: 4 X LR6 / Remote display:
4 X LR6).
1 2
1 : Batteries full
3
4
Network radio signal strength
The IntelliPool® network signal strength depends on the geographic location of the Radio relay (long distance, pool situated
above the house, and the presence of an enclosing wall are detrimental), on the house materials (reinforced concrete and
metal buildings are detrimental) and on the Radio relay bracket (metal pickets or galvanised drainpipes are detrimental).
If after testing different radio relay location configurations, the network signal remains too low or non-existent, place a second
1
2
Radio relay between equipment room and remote display to optimise the signal strength (test before fixing the elements).
3
4
Adding an element to the IntelliPool® radio network entails programming it (see p31).
5
Pool cover position
For swimming pools equipped with a pool cover and after the connection is made on Control center, the position (cover
unfolded, cover wrapped) is displayed.
2 : Batteries ok 3 : Batteries very low 4 : Batteries to replacen
29