Outdoor Remote Control; Radio Relay - Pentair INTELLIPOOL AUTOMATION Guía De Instalación Y Usuario

Outdoor remote control

Designed to drive an auxiliary output and lighting from the edge of the pool, it is waterproof and floats if dropped in the pool. As the radio network
consists of several elements, it is normal for the start of a function to take a few seconds (1 to 10s depending on the configuration).
1 : Short press = button lighting ON / OFF
2 : Short press = button Aux1 ON-OFF, long press (>3s) = back wash (if present)
3 : (Simultaneous 3s) = Function SHOCK (24H forced filtration and desinfection, this feature can be useful after a strong activity in the pool).
4 : Radio antenna
6 : Serial number identification plate
8 : Battery hatch (button cell CR2032 supplied - Pull tab to open)
3
A

Radio relay

This element is necessary to relay the radio waves between the equipment room and home. It measures the outside temperature. With its shapes
and natural colors, designed for outdoor use, it takes place in the garden (or plant in a clump on his clip screwed to a wall). The battery life is
approximately 1 year. In case of long distance or garden with great relief, it is possible to add one or more Radio relay (see p31).
1 : Wall clip fixing holes
3 : Air temperature sensor
5 : Battery access tab
7 : Identification plate (inside)
9 : Jump position
9B : Air temperature is not transmitted (required for adding a radio relay, see p31).
3
2
1
5 : 3s LED blinking (after pressing) = Low battery cell
7 : Anti slip rubber foot
4
1
5
2
2 : Wall clip trap grooves
4 : Radio antenna
6 : Pot
8 : Battery holder contacts
9A : Air temperature is transmitted
A
4
5
6
7
model :
433.445 MHz
serial :
MADE IN FRANCE
Use only alkaline batteries of high quality
resistant to temperatures of +70 ° C (ex
DURACELL PROCELL)
A
6
7
433.445 MHz
MADE IN FRANCE
8
CR2032 x 1
A
8
9A
T°ext = ON
model :
serial :
9
9B
T°ext = OFF
13