Pentair INTELLIPOOL AUTOMATION Guía De Instalación Y Usuario página 36

CALIB MODE - Changing units & deliberate correction of values
In spite of calibration of measurement sensors, it may be that a value is out of line with another measurement reference (regular thermometer...).
For this reason you have the option of deliberately correcting certain values as the units of the air temperature & water temperature (factory
pre-setting °C) and the conductivity (factory pre-setting µS) or values of air temperature and water temperature.
1 - Push the switch to CALIB mode (rear face of indoor display).
2 - Set the value following the navigation operating principle.
3 - When the last modification is valited, set the switch back to ON mode
1
2
3
34
calib on alarm
1 = escape
- go back to previous stage without confirming modifications
2 = move down / decrease
- browse downward in scrolling menus or decrease values in numerical sections
3 = move up / increase
- browse upward in scrolling menus or increase values in numerical sections
4 = validate
- access the parameter displayed or validates modifications and goes back to the previous menu
calib on alarm
1 2 3 4