Pre-Operate Inspection; Engine Oil; Oil In The Reduction Gear Box - Lavorwash 160F Manual Para El Usuario

Remote-controlled choke:
PRE-OPERATION INSPECTION
I. ENGINE OIL
CAUTION
• Engine oil is a key factor in deciding the engine's performance. Do not apply engine oil
with additives or 2–stroke gasoline engine oil, as they haven't enough lubrication, which
may shorten the engine's service life.
• Check the engine with it stopped on a level ground.
SAE15W-40 (Fig. 5) is recommended for general, all
temperature use.
As viscosity varies with regions and temperatures, so
the lubricant has to be selected in accordance with our
recommendation.
Check (Fig. 6).
1. Ensure that the engine is stopped on a level ground.
2. Remove the dipstick and clean it.
3. Reinsert the dipstick into the oil filler without
screwing in, and check oil level.
4. If the oil level is too low, add the recommended
engine oil to the oil filler nick.
5. Reinstall the dipstick.
CAUTION
Run with insufficient engine oil may
damage the engine severely.
II. OIL IN THE REDUCTION GEAR
BOX (only for model equipped with it)
1/2 Reduction gear box with an auto centrifugal
clutch.
Brand of the oil is the same as that of engine oil.
Oil capacity: 0. 50 liters
Check the oil level in the following order (Fig. 7):
1. Remove the dipstick and clean it.
2. Reinsert the dipstick without screwing it in,
and then take out it and check oil level.
3. If the oil level is too low, add the recommended
engine oil until it arrives the upper level mark.
4. Reinstall the dipstick.
Steel wire fixer
Choke lever
SAE
TEMP
Dipstick
Upper lever
mark
Oil capacity 0.50 liters
Upper lever
mark
EN
fig. 4
fig. 5
fig. 6
Dipstick
Drain plug
fig. 7
27