Error Messages While Establishing A Connection With The Cockpit App - Ottobock C-Brace 17KO1 Serie Instrucciones De Uso

Symbols Beep
on the signal
control
panel
— 1 x short
—
— —

15.2.2 Error messages while establishing a connection with the cockpit app

Error message
Component was con­
nected to another
device. Establish con­
nection?
96
Vibra­ Event
tion
signal
1 x Mode switching or changing
short adjustment parameters is
performed using the Cockpit
app.
If the parameter "Volume of
acoustic signal" is set to
"0" in the Cockpit app, only
a vibration signal is emitted.
— The product switches itself
off. This occurs automatically
in the following cases:
• The
control
pressed and held for
longer
3 seconds while product
was switched on.
• After
lights up.
• After disconnecting the
battery charger, if the
product
switched off before con­
necting the battery char­
ger.
Total failure
ongo­
ing Electronic control no longer
possible. Safety mode active
or undetermined valve state.
Undetermined product beha­
viour.
Cause
The component was
connected to another
device
button on the
panel was
than approx.
the symbol
was already
Correction
To disconnect the original connection, tap
the "OK" button.
If the original connection is not to be dis­
connected, tap the "Cancel" button.
Required action
• Charge the battery.
• If desired, switch on the
product with the
1. Press and hold the
on the control panel until the
vibration signal stops (approx.
10 seconds),
switching off the product.
2. If the vibration signal recurs
after switching on, attempt to
reset this error by connect­
ing/disconnecting the battery
charger.
3. If the vibration signal recurs,
use of the product is prohib­
ited. The product must be
inspected by an O&P profes­
sional.
button.
button
completely