Connecting The Power Supply And Battery Charger - Ottobock C-Brace 17KO1 Serie Instrucciones De Uso

Ocultar thumbs Ver también para C-Brace 17KO1 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 207
Use the 757L16-4 power supply and 4E50-2 battery charger to charge the battery.
With uninterrupted walking, the capacity of the fully charged battery is sufficient for at least 18
hours. It lasts about 2 days with average use.
Switching the MyModes and changing setting parameters using the Cockpit app is not pos­
sible during the charging process.
We recommend charging the product every day when used on a daily basis.
The battery should be charged for at least 3 hours prior to initial use.
For the maximum operating time with one battery charge, turning the product off when it is not
being used is recommended.
Switching the MyModes and changing setting parameters using the Cockpit app is not pos­
sible during the charging process.
After disconnecting the battery charger, the orthosis is in the same state it was in before con­
necting the battery charger. For example, if the orthosis was switched off before connecting
the battery charger, it will also be switched off after disconnecting the battery charger.

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see
fig. 1).
2) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Connect the round, three-pin plug of the power supply to the 12 V receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply (see fig. 3) and the green LED on the bat­
tery charger light up.
→ If the green LED on the power supply and the green LED on the battery charger do not light
up, there is an error (see Page 97).
2
3
69

Publicidad

Tabla de contenido
loading

Tabla de contenido