Delivery And Handling; Transportation; Storage; Identification - Grundfos SL1 Manual De Instrucciones

Ocultar thumbs Ver también para SL1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Delivery and handling

The pump may be transported and stored in a vertical or
horizontal position. Make sure that it cannot roll or fall over.

4.1 Transportation

All lifting equipment must be rated for the purpose and checked
for damage before any attempts to lift the pump. The lifting
equipment rating must under no circumstances be exceeded.
The pump weight is stated on the pump nameplate.
Warning
Always lift the pump by its lifting bracket or by
means of a fork-lift truck if the pump is fixed on a
pallet. Never lift the pump by means of the motor
cable or the hose/pipe.

4.2 Storage

During long periods of storage, the pump must be protected
against moisture and heat.
Storage temperature: -22 °F to +140 °F (-30 °C to +60 °C)
Warning
If the pumps are stored for more than one year or
it takes a long time before it is put into operation
after the installation, the impeller must be turned
at least once a month.
If the pump has been in use, the oil should be changed before
storage.
After a long period of storage, the pump should be inspected
before it is put into operation. Make sure that the impeller can
rotate freely. Pay special attention to the condition of the shaft
seal, O-rings, oil and the cable entry.

5. Identification

5.1 Nameplate

The nameplate states the operating data and approvals applying
to the pump. The nameplate is fitted to the side of the stator
housing close to the cable entry.
Fix the extra nameplate supplied with the pump to the cable end
in the controller.
1
2
3
4
9901063000000001
5
6
7
8
9
10
11
12
13
14
Fig. 3
Nameplate
Pos.
Description
1
FM marking
2
Thermally protected
3
Type designation
4
Serial number
5
Production code (year/week)
6
Maximum ambient temperature
7
Maximum head
8
Maximum flow rate
9
Rated input/output power
10
Rated voltage, D
11
Rated voltage, Y
12
Frequency
13
Country of production
14
CSA mark
15
FM mark
16
Enclosure class to IEC
17
Maximum installation depth
18
Power factor
19
Number of phases
20
Rated speed
21
Service factor
22
Full load current, D
23
Full load current, Y
24
Insulation class
25
Weight without cable
15
16
R
17
18
19
20
21
22
23
24
25
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Slv

Tabla de contenido