Kawasaki VERSYS 1000 Manual De Servicio página 39

Periodic Maintenance Procedures
•
I dle Speed Inspection
Start the engine and warm it up thoroughly. [A].
•
With the engine idling, turn the handlebars to both sides
If handlebars movement changes the idle speed, the throttle cables may be
improperly adjusted or incorrectly routed, or damaged Be sure to correct any
of these conditions before riding (see Throttle Control System Inspection and
Cable, Wire, and Hose Routing section in the Appendix chapter).
Operation with improperly adjusted, incorrectly routed or damaged
cables could result in an unsafe riding condition. Follow the service
manual to be make sure to correct any of these conditions.
•
Check the idle speed.
If the idle speed is out of specified range, adjust it.
Idle Speed
Standard 1 100 ±50 r/min (rpm)
•
I dle Speed Adjustment
Start the engine and warm it up thoroughly.
•
Turn the adjusting screw [A] until the idle speed is correct. Open and close the
○
throttle a few times to make sure that
the idle speed is within the specified range. Readjust if necessary.
•
T hrottle Control System Inspection
Check that the throttle grip [A] moves smoothly from full open to close, and
the throttle closes quickly and com- pletely by the return spring in all steering
positions.
If the throttle grip does not return properly, check the throt- tle cable routing,
grip free play, and cable damage. Then
lubricate the throttle cable.
•
Check the throttle grip free play [B].
Throttle Grip Free Play
Standard 2 "< 3 mm (0.08 "< 0.12 in.)
If the free play is incorrect, adjust the throttle cable as
follows.
•
Loosen the locknuts [A] [B].
•
Screw both throttle cable adjusters [C] [D] to give the
throttle grip plenty of play.
•
Turn the decelerator cable adjuster [D] until there is no
play when the throttle grip play completely closed.
•
Tighten the locknut [B].
•
Turn the accelerator cable adjuster [C] until 2 "< 3 mm
(0.08 "< 0.12 in.) of throttle grip play is obtained. Tighten the
•
locknut [A].
If the free play can not be adjusted with the adjusters, replace the cable.
WARNING
PERIODIC MAINTENANCE 2-17