Periodic Maintenance Procedures
•
Fill the radiator up to the filler neck [A] with coolant.
○
Pour in the coolant slowly so that it can expel the air from the engine and
radiator.
•
Check the cooling system for leaks.
•
Tap the water hoses to force any air bubbles caught in-
side.
•
Fill the radiator up to the filler neck with coolant. Install the radiator
•
cap.
•
Fill the reserve tank up to the "F" (full) level line [A] with
coolant and install the cap [B].
•
Start the engine, warm it up thoroughly until the radiator
fan turns on and then stop the engine.
•
Check the coolant level in the reserve tank after the en-
gine cools down.
If the coolant level is lower than the "L" (low) level line [C], add coolant to the
"F" level line.
Do not add more coolant above the "F" level line.
NOTE
NOTICE
PERIODIC MAINTENANCE 2-27