Breville the Sous Chef Manual De Instrucciones página 12

NOTE
The food processor will not operate unless
both the processing bowl and lid are correctly
locked into position.
CAUTION
The processing blades (including the mini
bowl blade) and discs are extremely sharp,
handle with care at all times.
7. Insert the power plug into a 110/120V
power outlet.
8. Press the POWER/OFF button to turn
your food processor on. The red light will
illuminate around the POWER /OFF button
to indicate that the processor is on.
9. Press the START/PAUSE button to switch
the motor on and operate continuously.
NOTE
The food processor will not start unless the
large food pusher is inserted correctly
into place.
10. Press the POWER/OFF button to switch
the motor off. When short bursts of power
are required, press the PULSE button and
hold down briefly, release, then press again.
The PULSE action will automatically stop
when the button is released.
12
BFP800 USCM IB_K20.indb 12 BFP800 USCM IB_K20.indb 12
11. To set the timer, press the
located to the left of the timing window.
Time will move up by 5 second intervals,
from 0 to 30 seconds. From 30 seconds
to 2 minutes the time will increase in
10 second intervals and from 2 minutes
to 9.59 minutes the time will increases in
20 second intervals.
NOTE
If a time is not set, the timer will automatically
count up during processing.
12. Once the time is set, press the START/
PAUSE button and the timer will start to
count down.
13. Ensure the large food pusher is inserted
correctly into place. The food processor
will not start until pusher is in place. Once
the timer has finished, the food processor
will stop and go into STANDBY mode.
Three (3) beeps will sound to indicate that
the processing is complete. The processor
incorporates a 'Safety Interlock System' that
ensures the unit will not start without the
large food pusher in position. Processing
will stop automatically, once the large food
pusher has been removed from the lid.
The CHUTE FILL MAX graphic indicates
the maximum volume of food to be placed
in the chute for the pusher to activate the
unit.
14. At the end of processing, always wait until
the blades or discs have stopped spinning
before unlocking and removing the lid.
To remove the processing lid, ensure the
POWER/OFF button has been pressed,
and the cord is unplugged from the power
outlet. Holding the feed chute and pressing
down firmly at the same time, turn the
lid counter-clockwise so that the arrow
graphics are no longer aligned.
buttons
25/9/20 1:46 pm 25/9/20 1:46 pm