Opex Falcon+ Manual Del Operador página 234

11. Swing the paper guide back over the graphics printer, and tighten its
thumbscrew (shown in Figure 5-5).
12. Close the stacker cover.
Adjusting the printer carriage position
You can adjust the vertical print position on items by moving the printer
carriage. The printer carriage is fixed to a shaft with detents that position the
printer so it sprays ink through the holes in the paper guide. A thumb screw
holds the printer in the detents. If you do not position the printer in a detent, the
thumb screw sticks out, preventing you from closing the paper guide.
To adjust the carriage position, loosen the thumb screw, slide the carriage to a
new detented position on the shaft, and then retighten the thumb screw (see
Figure 5-11).
Loosen thumb screw to
move carriage along
detent shaft
Figure 5-11: Adjusting Printer Carriage Position
Maintenance 117
Falcon+ Operator Manual
OPEX Corporation