Opex Falcon+ Manual Del Operador página 282

Table 5: Reasons for jams (continued)
MFD Skew Damage
Exceeded Sensor
Blocked
Out Of Bounds Sensor
Blocked
Out of Bounds Detected
Justification Sensor
Blocked
Feed Singulation Defeat
Button Stuck
Skew 9 Sensor Blocked
Skew 8 Sensor Blocked
Skew 7 Sensor Blocked
Skew 6 Sensor Blocked
Skew 5 Sensor Blocked
Skew 4 Sensor Blocked
Post Feed MFD Trail
Sensor Blocked
Stepper Stall Detected
Pre Crush Roller Sensor
Blocked
Feed Entry RX Present
Sensor Blocked
Fan Failure Detected
Roller Bed Motor Fault
Detected
The MFD Skew Damage Exceeded Sensor is
blocked.
The Out Of Bounds Sensor is blocked.
A piece is too tall for the imager.
The Justification Sensor is blocked.
The override feed control button is stuck in a
down position.
The Skew 9 Sensor is blocked.
The Skew 8 Sensor is blocked.
The Skew 7 Sensor is blocked.
The Skew 6 Sensor is blocked.
The Skew 5 Sensor is blocked.
The Skew 4 Sensor is blocked.
The Post Feed MFD Trail Sensor is blocked.
A Stepper Motor has stalled.
The Pre Crush Roller Sensor is blocked.
The Feed Entry RX Present Sensor is blocked.
A fan has stopped functioning.
This event can occur during a job activation of
the roller bed motor and a stall, over-current,
under-current, thermal warning or thermal
shutdown is detected by the stepper controller.
Falcon+ Operator Manual
OPEX Corporation
141