Mount Axis - Festo ELGA-TB-G Instrucciones De Utilizacion

ELGA-TB-G/-KF/-RF
Mounting position vertical or diagonal
WARNING
Uncontrolled payload if there is a power failure or
the toothed belt breaks.
Injury due to impact or pinching.
With vertical or diagonal mounting position:
• Use motors with spring-loaded holding brakes.
• Take appropriate safety measures to prevent dam­
age if the toothed belt breaks (e.g. toothed latches,
bolts or an emergency buffer).
5.1.1

Mount axis

Requirements
• Position the product in such a way that its control sections are accessible (e.g. relubrication open­
ings).
• Install product without tension or distortions.
• Fasten product to a mounting surface with flatness of 0.05 % of
the stoke length, but max. 0.5 mm.
For gantry applications, attention must also be paid to parallel
alignment or product heights in alignment of the axes.
For additional information, contact your local Festo Service.
• Take the required support spacing into account
(è 13 Characteristic curves).
Festo – ELGA-TB-G/-KF/-RF – 1502c English
Fig. 6
Fig. 7
33