Hilti POS 150 Manual De Instrucciones página 48

2. Select station point
3. Select orientation points
4. Select the orientation points or start the calculation
Return to previous dialog
@
Start the dialog to measure the orientation
; points
Start the calculation (possible only after at least
= one orientation point has been measured)
Select station point
%
Setting the height of the device
&
Return to previous dialog
@
Set the orientation angle (only the angle is to
; set, no measurement is taken)
Take the measurement to the orientation point
=
Confirm dialog
%
Select orientation point
&
Set the reflector height
(
Return to previous dialog
@
Dialog for measuring orientation points. Start
; the dialog again for each orientation point.
Start the calculation (possible only after at least
= one orientation point has been measured)
en
47