Hilti POS 150 Manual De Instrucciones página 50

3. Select the reference points
4. Select the orientation points or start the calculation
5. Set station
Return to previous dialog
@
Take the measurement to the reference point
;
Confirm dialog
=
Select the reference point
%
Set the reflector height
&
Display the reference points already measured
( and display the differences.
Return to previous dialog
@
Start the dialog to measure the reference points
;
Start the calculation (possible only after at least
= 2 reference points have been measured)
Return to previous dialog
@
Set the height of the station (see no. 6)
;
Display results
=
Set station
%
If there are more than two reference points
& the standard deviations "StDev(HA)" and
"StdDev(H)" are displayed.
en
49