Procedure For Application "Reference Line With Prism - Hilti POS 150 Manual De Instrucciones

8.6.1 Procedure for application "Reference line with prism"

1. Start dialog "Reference line"
en
2. Entry dialog "Control line definition"
3. Entry dialog "Displacements"
58
Select "Reference line" application
@
Return to previous dialog
@
Definition and selection of control line from
; drawing
Definition of control line from coordinate list
=
Definition of control line from point measure-
% ment
If the control line has been defined, continue to
& displacement dialog
Return to control line definition
@
Confirm the displacement entries. Continue
; with entry dialog for longitudinal, lateral and
height values.