4. Set station
7.2 Setting up the tool with height
If heights are also to be used in addition to setting the station and orientation, i.e. target heights are to be determined
or laid out, the height of the center of the telescope must also be defined.
Dialog for determining height
Return to previous dialog
@
Set the height of the station (see no. 5)
;
Display results
=
Set station
%
Display the name of the station
&
Return to previous dialog
@
Entering the height manually
;
Initiate measurement
=
Confirm dialog
%
Selecting height points
&
Setting the height of the device
(
Setting the reflector height
)
Return to previous dialog
@
Select the height above the point
;
Initiate measurement
=
Confirm dialog
%
Select the height point / height mark
&
Setting the height of the device
(
Set the reflector height
)
en
51