Procedure For "Missing Line" Application; Reference Line - Hilti POS 150 Manual De Instrucciones

8.5.2 Procedure for "missing line" application

1. Start dialog "Missing line"
2. Measurement dialog "Measuring point 1"
3. Measurement dialog "Measuring point 2"

8.6 Reference line

The reference line application is an application that deals with the handling of lines and curves. The reference line
application can be used to calculate and set out control lines using coordinates, to record control lines marked on the
construction site and to move lines in a defined way. In addition, points with longitudinal and lateral dimensions with
reference to the defined control line can be set out directly.
This is particularly easy when the control line is previously defined as a graphical line or curve using coordinates. The
lines and curves can then be selected by the press of a finger without having to re-enter the lines or curves again
when changes are made.
Select missing line application
@
Return to project dialog
@
Initiate measurement
;
Continue to next dialog after measurement
=
OK
@
Entry and display of the attributes assigned to
; the point
Initiate measurement
=
Display results
%
en
57