Suzuki GD115 Manual Del Propietário página 68

GD115 99011-36H51-01D
WARNING
Hard braking while turning, on wet, loose, rough,
or other slippery surface may cause wheel skid
and loss of control.
WARNING
If the rider brakes suddenly in turns, the
motorcycle will lose control. The correct method
is to brake before turns to slow down.
WARNING
Use the braking system carefully and gently on
wet and slippery roads or in turns. Urgent braking
on uneven or slippery roads will cause the
motorcycle to be out of control.
WARNING
Following another vehicle too closely can lead to
a collision. As motorcycle speeds increase,
stopping distance increases progressively. Be
sure you have a safe stopping distance between
you and the vehicle in front of you.
WARNING
The muffler will be very hot when the engine is
running or shortly after it is shut down. Do not
touch it at this time; otherwise you will get a burn.
V01 Export ENG 2014-08-11
WARNING
Riding too close to other vehicles will result in
rear-end collisions. A greater riding speed should
correspond with a longer braking distance. Make
sure there is a safe braking distance between the
motorcycle and the vehicle in front of it.
CAUTION
If other antitheft locks such as a U-shaped lock, a
brake disc lock and a chain lock are used for
prevention of thievery, the antitheft lock should
be taken off before the starting of the motorcycle.
INSPECTION AND MAINTENANCE
MAINTENANCE SCHEDULE
The chart indicates intervals between periodic services
in kilometers and months. At the end of each interval, be
sure to inspect, check, lubricate and service as
instructed. If your motorcycle is used under high stress
conditions such as continuous full throttle operation, or is
operated in a dusty climate, certain services should be
performed more often to ensure reliability of the
motorcycle, as explained in the maintenance section.
Your SUZUKI dealer can provide you with further
guidelines. Steering components, suspensions and
wheel components are key items and require very
special and careful servicing. For maximum safety, we
19