Suzuki GD115 Manual Del Propietário página 76

GD115 99011-36H51-01D
Oil level check
Inspect the engine oil level following the steps below.
1. Stop the engine and support it on a flat ground with
the help of the main stand.
2. Start the engine and have it run for several minutes.
3. After the engine has been stopped for several minutes,
remove the engine oil dipstick, wipe it, insert it into the
engine oil without turning it and then take it out to
check the engine oil level. The engine oil level should
be between the UPPER LEVEL and LOWER LEVEL
on the engine oil dipstick.
CAUTION
If the engine oil level is lower than the LOWER
LEVEL on the engine oil dipstick, do not start the
engine. When adding engine oil makes sure the
engine oil level is not higher than the UPPER
LEVEL. It is suggested to add engine oil till the
two-thirds position of the engine oil dipstick.
CAUTION
Engine oil tiny consumes in normal operating
conditions, which is normal. Add engine oil
promptly.
V01 Export ENG 2014-08-11
CAUTION
If the engine
abnormally, have the motorcycle inspected by a
repair shop in time.
Engine oil change
Replace the engine oil with new oil after the engine is in
a hot state to completely drain the original engine oil.
Steps for engine oil replacement:
1. Stop the engine and support it on flat ground with the
help of the main stand.
2. Remove the engine oil dipstick (oil filling port cap) 1.
3. Dismantle the drain plug 2 and its washer to drain the
original engine oil.
4. Tighten the drain plug 2 and its washer.
5. Fill 900 milliliter of new engine oil into the engine via
the oil filling port. If the engine oil filter element is
replaced at the same time, make the volume of the
new engine oil 1000ml. Then properly tighten the oil
filling port cap 1.
6. Start the engine and have it run for several minutes.
7. Stop the engine and inspect the engine oil with the
dipstick several minutes later. The engine oil level
should be between the UPPER LEVEL and the
LOWER LEVEL.
27
oil consumption increases