Suzuki GD115 Manual Del Propietário página 82

GD115 99011-36H51-01D
Abrasion limit of rear brake
There is a wear limit mark on the
rear brake of the motorcycle.
Inspect the wear situation of the
rear brake following the essentials
below.
1. Inspect whether the
system has been
adjusted.
2. Operate the braking system and
inspect and make sure the mark extending line 1 is in
the allowed range 3 (see the figure) marked on the
wear limit mark 2, otherwise have the component in
the rear brake replaced by a qualified distribution and
maintenance organization for safety.
TIRES
Periodic checks should be performed for tire pressure
and tire wear status. To ensure maximum safety and life,
check the tire frequently, in addition to the scheduled
inspections.
WARNING
Tire pressure and wear status are very important
for the performance and safety of the motorcycle.
Be sure to check tire pressure and tire wear
status regularly.
Tire pressure
Under normal temperature, test the tire pressure by
using a tire pressure gauge, set the pressure base on
V01 Export ENG
braking
The mark
properly
extending line is in
the allowed range
2014-08-11
the pressure value recommended by this manual. If the
pressure is too high or too low, it will affect ride stability,
and will cause the tire to wear.
Standard for tire pressure under normal temperature
kPa
Front wheel
Rear wheel
The tire pressures and surfaces are significant. If
they are neglected, the safety of the rider may be
endangered and the motorcycle may be damaged.
Please inspect
surfaces of the tires of the motorcycle frequently.
Tire wear status
There are serial "T.W.I. ;" marks
1 (tire wear indicator) in the edge
of the tire. Check the bulge stock
2 of T.W.I. in the tread near the
mark. If the tire wears off to reach
the bulge stock, the tire should be
replaced.
Check the damage 3 (punctures or fractures) on the tire
surface visually. As surface damage may impede driving
stability, such tires should be replaced.
33
Solo riding Double riding
kgf/cm² kPa
175 1.75 175
200 2.00 225
WARNING
WARNING
the internal pressures
kgf/cm²
1.75
2.25
and