Spark Plug - Suzuki GD115 Manual Del Propietário

GD115 99011-36H51-01D
CAUTION
The dust shall be removed from one side, close to
the engine, of the filter element to the other side;
or else, the dust will be detained in the filter
element to prevent air flow from entering the filter
element.
FUEL COLLECTING PIPE
After the air filter is inspected,
inspect the fuel collection of the
fuel collecting pipe at its rear lower
part. If there is fuel in the fuel
collecting pipe, drain it promptly
with the method below.
1. Loosen the clamp 1.
2. Remove the fuel collecting pipe 2 together with the
clamp 1.
3. Drain all the waste fuel in the fuel collecting pipe 2.
4. Reinstall the fuel collecting pipe 2 and fasten the
clamp 1.
NOTE: When the air is very humid, properly increase the
inspection frequency.
V01 Export ENG 2014-08-11

SPARK PLUG

Spark plug inspection
Measure the spark plug gap with a thickness gauge. The
standard spark plug gap is 0.6-0.7 mm. If the measured
spark plug gap is out of standard range, adjust or
replace it with a new one.
Whenever removing carbon deposits, be sure to observe
the operational color of the spark plug's porcelain tip.
This color tells you whether or not the standard spark
plug is suitable for your type usage. A normal operating
spark plug should be very light brown in color. If the
spark plug is very white or glazed in appearance, it has
been operating much too hot. This spark plug should be
replaced with a colder plug.
Spark plug replacement guide
CAUTION
An improper spark plug may have an incorrect fit
or heat range for your engine. This may cause
severe engine damage.
25
0.6-0.7mm