Product Information; Type Key; Technical Data - salmson LRL Serie Manual De Instalación Y Puesta En Servicio

English
5

Product information

5.1

Type key

5.2

Technical data

Property
Rated speed
Nominal diameters DN
Permissible min./max. fluid temperature
Max. ambient temperature
Maximum permissible operating pressure 10 bar
Insulation class
Protection class
Pipe and pressure measurement connec-
tions
Approved fluids
Electrical connection
Motor protection
Speed control
Explosion protection
Suitability for potable water
28
The type key consists of the following elements:
Example: LRL/JRL 205-10.5/0.75 (P2)
LRL Flange-end pump as Inline pump
JRL Flange-end pump as Double pump
2 Number of motor poles
05 Nominal diameter DN of the pipe connection [cm]
10.5 Nominal impeller diameter [cm]
0.75 Nominal motor power P
P2 Standard version variant: Potable water approval acc.
to ACS (see www.salmson.com)
K1 Standard version variant: Outdoor installation
"Western European climate" (motor with protective
fan cover)
K4 Standard version variant: Outdoor installation
"Western European climate" (motor with protective
fan cover, additional standby heating 1~230 V)
K3 Standard version variant:
3 PTC thermistor sensors
Value
2900 or 1450 rpm
LRL: 25 to 100
JRL: 32 to 100
-20 °C to +120 °C
(depending on the fluid and type of mechanical
seal)
+ 40 °C
F
IP 55
PN 10 flange in accordance with EN 1092-2
With pressure measuring connections Rp
In accordance with DIN 3858
Heating water according to VDI 2035
Cooling/cold water
Water/glycol mixture up to 40 Vol.-%
3~400 V, 50 Hz,
3~230 V, 50 Hz, (up to 3 kW inclusive)
Required onsite
Control devices
(Salmson-VR system, Salmson-CC system)
As a special version, only possible for pump series
LRLA in conjunction with the Salmson supple-
mentary ATEX installation and operating instruc-
tions for pump types:
SIL/DIL/PBS,
LRL/LRLA/JRL/JRLA
Possible as special version P2.
Observe Salmson supplementary installation and
operating instructions.
When ordering spare parts, make sure to state all the information
given on the pump and motor rating plates.
[kW]
2
Remarks
1
/
8
For special versions,
e.g. for other voltages,
operating pressures,
fluids, etc. see rating
plate or visit
www.salmson.com.
Salmson 12/2017