Sun Microsystems Fire V480 Guía De Instalación Y Montaje página 23

2
C H A PT E R
Installing a Sun Fire V480
Server Into a 2-Post Rack
This chapter provides step-by-step instructions for installing a Sun Fire V480 server
into a 2-post rack.
Note - When a Sun Fire V480 server is installed in a 2-post rack, only the disk
drives and power supplies are serviceable in the rack. You need to remove the server
from the rack to service any other component. See the Sun Fire V480 Server Parts
Installation and Removal Guide for more information.
This chapter contains the following procedures and information:
"Checklist of 2-Post Rackmounting and Setup Tasks" on page 20
"Inventory for 2-Post Rackmounting" on page 21
"Attach the Mounting Brackets to the Chassis" on page 22
"Locate the Mounting Holes" on page 23
"Install the Mounting Screws" on page 24
"Install the Server Into the Rack" on page 25
"Install the Server Into a Populated Rack" on page 26
en-19