Install The Mounting Screws - Sun Microsystems Fire V480 Guía De Instalación Y Montaje

Note – If you are installing the server into a space less than seven rack units, you do
not need to locate mounting holes or install mounting screws. You are ready to
install the server into the rack. See "Install the Server Into a Populated Rack" on
page 26.

Install the Mounting Screws

Install one 10-32 x 1/2 screw on the left and one 10-32 x 1/2 screw on the right
vertical mounting rails.
Use the holes you marked in the previous step. Do not fully tighten the screws until
after you install the server. Leave a 0.25-inch (0.64-cm) gap between the head of each
screw and the mounting rail.
0,64 cm
10-32 x 1/2
10-32 x 1/2
en-24 Sun Fire V480 Server Setup and Rackmounting Guide • February 2002