Install The Server Into The Cabinet - Sun Microsystems Fire V480 Guía De Instalación Y Montaje

Install the Server Into the Cabinet

Caution – Before you install or remove the server from the cabinet, be sure the
!
cabinet is stabilized so that it cannot move or tip forward. See the cabinet
documentation for information about stabilizing the cabinet.
Caution – The server is heavy. Two persons are required to move the server.
!
Note – Make sure that each slide assembly is fully retracted into the cabinet and
check that the ball-bearing runner on each slide assembly is all the way forward.
1. Lift the server (one person on each side of the server) and approach the cabinet
with the back of the server facing the front of the cabinet.
2. Align the rounded ends of the inner glides on the server with the slide assemblies
in the cabinet.
Note – Make sure that the inner glides attached to the server are inserted within the
ball-bearing runners.
en-14 Sun Fire V480 Server Setup and Rackmounting Guide • February 2002