Sun Microsystems Fire V480 Guía De Instalación Y Montaje página 24

Checklist of 2-Post Rackmounting and
Setup Tasks
TABLE 2-1
Step
1
2
3
4
5
6
7
8
Note – The steps are different if you are installing the server into a populated rack.
See "Install the Server Into a Populated Rack" on page 26 for instructions.
en-20 Sun Fire V480 Server Setup and Rackmounting Guide • February 2002
Overview of 2-Post Rackmounting and Setup Steps
Task
Unpack the rackmounting kit and
verify the contents.
Attach the brackets to the server.
Locate the mounting holes.
Install the mounting screws.
Install the server into the rack.
Install the cable management arm.
Connect the power cords.
Connect a twisted-pair Ethernet
(TPE) cable
Refer to:
"Inventory for 2-Post Rackmounting" on
page 21
"Attach the Mounting Brackets to the
Chassis" on page 22
"Locate the Mounting Holes" on page 23
"Install the Mounting Screws" on page 24
"Install the Server Into the Rack" on page 25
"Install the Cable Management Arm" on
page 30
"Connect the Power Cords" on page 34
"Connect a Twisted-Pair Ethernet Cable" on
page 37