Wind Deflector; Retention System 58 H; Chinstrap With Micro-Lock Ratchet Fastener - SCHUBERTH S2 Manual Del Usuario

C. THE HElMET

8. WIND DEFLECTOR

The wind defl ector prevents the unpleasant effect of the wind
created as you ride fl owing into the helmet. In addition, the
riding noise in the helmet is reduced.
1. The wind defl ector is attached
by Velcro strips on the inside of
the acoustic collar and can be
removed when required to provide
an additional fl ow of fresh air,
especially in hot weather.
Tip:
The fi t of the bottom of the helmet is extremely important in
ensuring that the helmet is as quiet as possible. If you have a
smaller collar size, we recommend that you also wear a scarf.
9. RETENTION SYSTEM
The retention system of the S2 consists of a chinstrap that is
additionally secured with neckbands at the back of the helmet
shell (the anti-roll-off system, see section C.14.).

Chinstrap with Micro-Lock ratchet fastener

The S2 comes with a ratchet fastener. This
locking system is easy to use and
enables you to adjust the chinstrap
perfectly to your head every
time you put the helmet on.
58
Adjusting the chinstrap
The length of the chinstrap is adjusted by increasing or reducing
the length of strap pulled through the metal buckle. Adjust the
length of the chinstrap so that it fi ts fi rmly but comfortably
under your chin and fi x the end of the strap using the retaining
loop with comfort pad.
Caution:
When adjusting the strap, make sure that the helmet cannot
be pulled off in a forward direction with the chinstrap closed
Caution:
Check the adjustment of the chinstrap length at regular
intervals (see section E.2.).
Opening and closing
To close the chinstrap fastener, slide the ratchet tongue step by
step into the locking buckle. If you fi nd that the chinstrap fi ts
too loosely around your chin, slide the ratchet tongue one step
further into the locking buckle.
When adjusting the chinstrap, make sure that it rests fi rmly but
not uncomfortably around your chin. To open the chinstrap, pull
59