Pinlock ® Visor - SCHUBERTH S2 Manual Del Usuario

C. THE HElMET
the red ribbon on the ratchet fastener upwards to release the
locking buckle. Then pull the ratchet tongue out of the locking
buckle.
Caution :
Never ride without making sure that the chinstrap is correctly
fastened and adjusted and properly positioned. If the
chinstrap is not correctly adjusted or fastened, the helmet
could be displaced in the event of an accident.
Caution :
Closing the comfort pad of the chinstrap alone will not
provide adequate protection. The chinstrap must always be
fully fastened.
Caution :
Never open the chinstrap while riding.
®
10. PINLOCK VISOR
The Pinlock ® visor is a double-wall visor that does not mist up.
The two visor plates are separated from each other and sealed
with transparent, fl exible silicone. The inner visor plate is fi xed
in place by eccentric pins, which pretensions the two visor plates
towards each other and creates the sealing effect. An insulating
air cushion is thus formed between the visor's main plate –
i.e. the outer plate – and the inner plate, which prevents any
fogging up of the inner plate.
60
COATING
The main plate has a HighClear ®
sides.
Note:
The helmet should never be used to hold gloves or any other
objects as this may damage the scratch-sensitive Pinlock
inner visor shield.
Note:
The Pinlock ® inner visor is supplied with a protective fi lm.
Remove this fi lm before using the helmet for the fi rst time.
Note:
The Pinlock ® inner visor may only be used in conjunction
with the SCHUBERTH main face shield that has been specially
designed for this purpose. Other face shields must not be
fi tted.
Opening the face shield
To open the face shield, use your thumb to
push the face shield up using one of the fi nger
tabs situated to the left and right of the face
shield, and move it to the desired position.
Face shield (including urban position)
The face shield can be locked in any one of seven positions.
The second position (urban position) locks in place more fi rmly,
providing greater resistance when the face shield is in this
position. This makes it easier to lock the face shield in the urban
position, especially while riding.
anti-scratch coating on both
®
61