VWR shiroGEL Vertical 20 Manual De Instrucciones página 16

Converting the shiroGEL VERTICAL 20 from a 2- to 4-gel
Configuration
The thicker green sliding gel clamps are recommended to secure up to 2 gels (i.e. 1
gel either side of the PAGE insert) for gels up to a mum thickness of 2mm. For 4
gels (i.e. 2 gels either side of the PAGE insert: made using 1 plain glass plate and 1
notched glass plate, both with bonded spacers, and 1 notched plate without
spacers), the thinner YELLOW sliding gel clamps must be used.
To convert the shiroGEL VERTICAL 20 from a 2- to 4-gel configuration please
adhere to the following instructions.
1. To replace the green sliding gel clamps,
begin by unscrewing the color-coded
vertical screw pins. There should be no
glass plates within the PAGE insert, in the
side(s) being unscrewed. Once the screw
pins are unscrewed sufficiently the green
clamp should sit in the resting slot as
shown.
2. Gently push the green sliding clamp
horizontally towards the core of PAGE
insert until it can move no further.
3. Push the green sliding gel clamp out of
the PAGE insert by gently pressing the
protruding pin as shown.
13