Commands For Initialisation And Diagnostics - Festo EasyPort USB Manual De Instrucciones

9. EasyPort USB command interpreter
9.4
Commands for
initialisation and
diagnostics
Command Response
setup0 setup<n>
DV V=2.10
Initialisation and diagnostics
140 140
In addition to commands for reading and writing signals, there are other
commands that are primarily used for commissioning and diagnostics.
These include the following commands:
Query the address of an EasyPort USB module
Query the version number of an EasyPort USB module
Read out the status word of an EasyPort USB module
Description and example
Query address
The EasyPort USB module responds with its module address by reading out
setup <n> (<n> = 1...4).
Example
Command Response
setup0 setup1
Read out version number
The EasyPort USB module responds with V=2.10 as its version.
Description
The EasyPort USB module responds with
address 1 as its address.
© Festo Didactic GmbH & Co. KG „ 721876