Festo EasyPort USB Manual De Instrucciones página 93

1. Introduction
Controlling an actual
process
Software used for
controlling processes:
‟ FluidSIM (digital only)
‟ S7‟PLCSIM
‟ CoDeSys Soft-SPS
EasyPort USB interface:
Digital/analogue
interface
The EasyPort USB is the
interface between the
PC and the actual
process. The process is
controlled from the PC.
Actual process:
‟ Simulation box,
digital/analogue
‟ MPS PA
‟ MPS
‟ TP301
Sample applications for EasyPort USB
© Festo Didactic GmbH & Co. KG „ 721876
Controlling a simulated
process
Software used for
simulating processes:
‟ EasyVeep
‟ FluidSIM
‟ CIROS
EasyPort USB interface:
Digital interface
The EasyPort USB is the
interface between the
PC and the PLC. The PLC
controls the simulated
process at the PC.
Actual controller:
‟ Any PLC
‟ Simulation box, digital
‟ SPS EduTrainer
‟ PLC board
Measuring
Software used for
recording measured
values:
‟ FluidLab PA
‟ FluidLab P
‟ FluidLab H
EasyPort USB
interface:
Digital/analogue
interface
The EasyPort USB is
the interface between
the PC and actual
sensors.
Actual sensors:
‟ Simulation box,
digital/analogue
‟ MPS PA
‟ TP210
‟ TP610
Regulating
Software used for
regulation:
‟ FluidLab PA
‟ FluidLab P as of
ersion 2.0
EasyPort USB
interface:
Digital/analogue
interface
The EasyPort USB is
the interface between
the PC and the actual
controlled system.
Actual controlled
system:
‟ Simulation box,
digital/analogue
‟ MPS PA
‟ TP210
‟ TP610
93