Festo EasyPort USB Manual De Instrucciones página 157

9. EasyPort USB command interpreter
Command Description
MG<n>.0=x.xx
Assign a gain factor to physical unit of measurement volt
The measured value with the unit of measurement volt which is displayed on the LCD
of the EasyPort USB module with address <n> (<n> = 1...4) is multiplied by a factor of
x.xx.
x.xx is a 3-digit decimal value.
MG<n>.1=x.xx
Assign a gain factor to physical unit of measurement bar
The measured value with the unit of measurement bar which is displayed on the LCD of
the EasyPort USB module with address <n> (<n> = 1...4) is multiplied by a factor of x.xx.
MG<n>.2=x.xx Assign a gain factor to physical unit of measurement PSI
The measured value with the unit of measurement PSI which is displayed on the LCD of
the EasyPort USB module with address <n> (<n> = 1...4) is multiplied by a factor of x.xx.
MG<n>.3=x.xx
Assign a gain factor to physical unit of measurement MPa
The measured value with the unit of measurement MPa which is displayed on the LCD
of the EasyPort USB module with address <n> (<n> = 1...4) is multiplied by a factor of
x.xx.
MG<n>.4=x.xx
Assign a gain factor to physical unit of measurement l/min
The measured value with the unit of measurement l/min which is displayed on the LCD
of the EasyPort USB module with address <n> (<n> = 1...4) is multiplied by a factor of
x.xx.
MG<n>.5=x.xx
Assign a gain factor to physical unit of measurement
The measured value with the unit of measurement
of the EasyPort USB module with address <n> (<n> = 1...4) is multiplied by a factor of
x.xx.
Assigning a gain factor for display on the LCD
© Festo Didactic GmbH & Co. KG „ 721876
o
C
o
C which is displayed on the LCD
157