Commands For Measuring Analogue Signals - Festo EasyPort USB Manual De Instrucciones

9. EasyPort USB command interpreter
9.7
Commands for measuring
analogue signals
Command Description
MS<n>=01
Activate analogue input channel 0
Activate analogue input channel 0 at the EasyPort USB module with address
<n> (<n> = 1...4) for automatic transmission of input values.
MS<n>=02
Activate analogue input channel 1
Activate analogue input channel 1 at the EasyPort USB module with address
<n> (<n> = 1...4) for automatic transmission of input values.
MS<n>=04
Activate analogue input channel 2
Activate analogue input channel 2 at the EasyPort USB module with address
<n> (<n> = 1...4) for automatic transmission of input values.
MS<n>=08
Activate analogue input channel 3
Activate analogue input channel 3 at the EasyPort USB module with address
<n> (<n> = 1...4) for automatic transmission of input values.
MS<n>=0F
Activate all analogue input channels
Activate analogue input channels 0 through 3 at the EasyPort USB module with address
<n> (<n> = 1...4) for automatic transmission of input values.
MS<n>=00
Deactivate all analogue input channels
Deactivate all analogue input channels at the EasyPort USB module with address
<n> (<n> = 1...4). Automatic read-out of input values is then no longer possible.
Activating analogue input channels
152
152
The EasyPort USB supports the recording of analogue measured values
with the help of special commands.
The measuring mode is activated with the MME command (modify
measuring mode). All analogue input values which are read in are then
read out at maximum speed.
The analogue channel for which values will be read out automatically is
selected with the MS command.
© Festo Didactic GmbH & Co. KG „ 721876