Festo EasyPort USB Manual De Instrucciones página 129

8. ActiveX control for EasyPort USB
© Festo Didactic GmbH & Co. KG „ 721876
Working with the demo application
1. Make sure that the EasyPort USB process interface is connected to a
24 V DC power supply.
Switch on the power supply for the EasyPort USB.
2. Connect the EasyPort USB process interface to the PC using the USB
cable included.
3. If the USB drivers required for operating the EasyPort USB have not
yet been installed on the PC, a corresponding message appears. If
this is the case, install the USB drivers. You'll need the EasyPort CD
ROM to this end.
4. Make sure that ActiveX control for EasyPort USB has been installed
on your PC.
129