Siemens SITRANS F Serie Manual De Usuario página 20

Connecting
3.2 Transmitter Wiring
6. Insert wires into wire entry holes and secure by tightening wire clamp screws (see figure
Note
Power Supply connector wires should be stripped AWG 12 - 18 stranded wire or solid
conductors.
7. Plug input power plug P10 into connector J10 and secure using two captive connector
8. Replace access cover. Make sure Keypad Enable switch is in the "Enable" position (see
9. If installing a Temperature Sensor board, go to Wiring Temperature Sensor to Transmitter
10. Connect the power cables to the appropriate power source (90-240 VAC @ 50/60 Hz or
11. Apply power.
18
above).
mounting screws.
below).
①
Keypad Enable Switch
(Page 22). If not, go to step 10.
CAUTION
Improper connections will damage power supply.
WARNING
Certain parts inside the device carry dangerous high voltage. The transmitter must be
grounded and the top cover closed before applying power to the device.
9-36 Vdc). Close top cover.
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02