Reflect Mount - Siemens SITRANS F Serie Manual De Usuario

Connecting
3.5 Sensor Installation
Mounting Supplies
The following items will be needed to mount the sensors (most are supplied):
● Flat blade screwdriver
● Mounting Frames or Mounting tracks
● Tape, chalk and a ruler or measuring tape
● Mounting Straps
● Spacer Bar
● Mounting Guide (for Direct Mount)
● Ultrasonic coupling compound
● Sensors (matched set)
3.5.2

Reflect Mount

Sensor Installation
Reflect Mount -Installation using Mounting Frames and Spacer Bar
1. After receiving the spacing index from the Installation Menu, prepare the pipe surface
2. Degrease the surface and remove any grit, corrosion, rust, loose paint, etc.
Before beginning refer to the Reflect Mount Installation diagram example below.
30
area where the sensors will be mounted.
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02