Siemens SITRANS F Serie Manual De Usuario página 30

Connecting
3.4 Programming the Transmitter
Table 3- 3 Pipe Configuration Option List Definitions
Options
Fully Developed Fully developed flow, as would be expected for very long straight pipe runs or installation downstream
of a flow condition.
1 Elbow Single 90 degree Elbow upstream of sensor installation.
Dble Elbow+ Double out-of-plane Elbows upstream of sensor installation.
Dble Elbow- Double in-plane Elbows upstream of sensor installation.
Valve Not available at this time.
Expander Pipe expansion upstream of sensor installation.
Reducer Pipe reduction upstream of sensor installation.
Norm Entry Not available at this time.
Header Inlet Header or pipe manifold upstream of sensor installation.
Intrusions Not available at this time.
Selecting Sensor
The following is a typical sensor selection procedure for D1H High Precision Sensors.
1. From the [Channel Setup] menu press the <Down Arrow> to select [install Xdcr].
2. Press the <Right Arrow> to [Transducer Model]. Press <Right Arrow> and scroll to
3. To select [Transducer Size], press <Right Arrow> and select [D1H]. Press <ENT>.
4. IMPORTANT: Record Number Index and Spacing Method.
28
[1011HP-T1]. Press <ENT>.
①
Select based on type.
②
Select based on size
③
After sensor is mounted select "Install.
Definitions
Operating Instructions, 7/2010, A5E03086486-02
FUS1010 IP65 NEMA 4X