Transmitter Wiring - Siemens SITRANS F Serie Manual De Usuario

3.2

Transmitter Wiring

Turn off main power before installing AC connections to the transmitter. Contact with
exposed wiring may lead to fire, electric shock or serious injury.
Note
If the transmitter is not already mounted and cabling has not been run, proceed to Mounting
the Transmitter (Page 13) before connecting power.
1. Open the transmitter top cover by releasing the cover latch.
2. Unscrew the two power supply access cover fasteners and remove access cover.
3. Locate power supply connector J10. Using a flat blade screwdriver, remove plug P10
①
Power Supply
②
Power Supply Access Cover
③
Fuse F1
④
Input Power Conn. J10
Figure 3-1 Input Power Plug (P10) Wiring
4. Pull the desired length of input power wires through a cable gland and into transmitter
5. Wire input power connector P10 for AC or DC power depending on power supply
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02
DANGER
from connector J10. Set aside.
case before wiring connector.
provided.
Note
Dress cables and make sure cable length is not excessive as to impede proper
replacement of access cover.
⑤
Stripped Wire
⑥
Connector Mounting Screws
⑦
Wire Clamp Screws
Connecting
3.2 Transmitter Wiring
17