Navigating The Menu - Siemens SITRANS F Serie Manual De Usuario

Connecting

3.3 Navigating the Menu

Note
*Do not attach this wire on the RTD side of the terminal.
3. Complete the temperature sensor current loop by shorting together terminals 1 and 4 of
4. Ground the voltage sensing leads (terminals 2 and 3 of TB2) by connecting them both to
5. Tighten all TB1 and TB2 terminal block screws.
6. Replace I/O Board and secure with four captive screws paying careful attention to pin
7. Replace Access Cover and finger tighten captive thumbscrew.
Note
TB3 and TB4 are also active analog inputs. See wiring table below.
Table 3- 1 TB3 and TB4 Wiring
Pin TB3 Function
1 AUX. 1 IN
2 AUX. 1 COM
3 AUX. 2 IN
4 AUX. 2 COM
Notes on Analog Input Modules
Dual Path Models
● All units use T1 to report liquid temperature.
● The Analog Input of temperature takes priority over the built-in RTD (Resistive Thermal
3.3 Navigating the Menu
Installation Menu Navigation
The Installation Menu Chart is a multi-level structure divided into three columns from left to right
Level A - lists the major menu categories.
Level B - list the menu cells associated with Level A. You can enter data into Level B menu cells that
are display parameters in a column at the right of the screen.
22
the unused TB2 temperature sensor terminal block.
terminal 5.
alignment.
TB4 Function
AUX. 3 IN Iin1 Input
AUX. 3 COM Iin1 Common
AUX. 4 IN Iin2 Input
AUX. 4 COM Iin2 Common
Device) measurement of temperature.
Use Description
Analog current
input referenced
to meter
ground.
Behaviour Load
4 to 20mA 200Ω
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02
Wiring
1000 ft.
Max w/o
factory
approval