Siemens SITRANS F Serie Manual De Usuario página 23

Wiring Temperature Sensor Board
1. Using a flat-blade screwdriver, loosen Terminal Block TB1 and TB2 screws.
2. Wire the RTD liquid 992EC temperature cable (1012EC) as shown in the table below:
Wire #1 (Black)
Wire #2 (Orange)
Wire #3 (Brown)
Wire #4 (Red)
Wire #5 GND/SHLD (Blue)
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02
①
Black
②
Orange
③
Brown
④
Red
⑤
Blue
Figure 3-3 Single Channel Temperature Sensor Inputs
992EC Series Cable
⑥
Short Terminals 1 and 4 (FUS1010 &
FUH1010 only. For FUE1010 connect
sensor to TB2).
⑦
Ground Terminals 2 and 3 to Terminal 5
⑧
To Sensor
⑨
992EC Series Cable
Terminal TB1
To TB1--1
To TB1--2
To TB1--3
To TB1--4
*To TB1--5
Connecting
3.2 Transmitter Wiring
21