Installing The Sensor - Siemens SITRANS F Serie Manual De Usuario

Installing the Sensor

1. Take either sensor and apply a continuous lengthwise 1/8-inch bead of coupling
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02
compound across the center of the sensor emitting surface.
①
F-Connector
②
Angled Edge
③
Transducer
Figure 3-7 Sensor
①
Front View
②
Spring Clip (Not present on some
models)
③
Sensor Clamping Screw
④
Spacer Bar
⑤
1012 Series Mounting Frame
Figure 3-8 Sensor Installation
3.5 Sensor Installation
④
Back End
⑤
Emitting Surface
⑥
Coupling Compound
⑥
Pipe
⑦
Mounting Strap Note: Optional 2nd
Mounting Strap shown. Larger pipes over
30 inches may need an additional
support.
⑧
Spacer Bar Platform and Clamping
Screw
⑨
Spacer Bar Reference Hole
⑩
Orientation for Single Beam Transducer
at 9 o'clock position
⑪
Orientation for Dual Beam Transducer at
10 & 2 o'clock positions
Connecting
33