Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Please read the following instructions
carefully before installing the product.
1. Only suitable if the approved vehicle has been
fitted with three-point safety belts that meet ECE
standard Nº 16 or equivalent.
2. Under no circumstances should the safety seat
be installed in the front seat of the car opposite
the direction of travel if the car is equipped with
an active airbag.
3. This car seat is designed to offer the optimal safety
in all installation modes described in this manual.
4. This child seat must be used wITH the harness
system for children weighing between 0 kg and
18 kg.
5. Ensure that the part of any abdominal belt or strap
should rest as low as possible over the child's hips,
on both sides.
6. Please read the instructions carefully, as incorrect
installation could result in serious injury. If any
injuries should occur as a result of incorrect
installation, the manufacturer will accept no
liability.
7. This child restraint system complies with the rules of
Regulation ECE 44/04 and can be installed in most
vehicles equipped with 3-point seat belts aligned
to ECE Regulation 16. Under no circumstances shall
this seat be fitted only with a 2-point lap belt.
34
8. Please never use the safety seat without its cover
or without the harness protectors.
9. Fastening a child dressed in outerwear could
reduce the efficiency of the restraint system.
10. Make sure to protect the child safety seat from
direct sunlight as it could heat up and hurt the
child.
11. Child seats or harness accessories that are
damaged or have been used incorrectly must be
replaced.
12. Do not leave heavy objects inside the car, as these
may injure the child in the event of an accident.
13. Make sure that the buckle is correctly fastened
so that the child can be quickly freed in case of
emergency.
14.The safety seat's rigid and plastic elements should
be positioned and installed so that they cannot
be trapped by a moving seat or a door during
everyday use of the vehicle.
15. Do not disassv emble, modify, or add any piece to
the child seat or harness, as this would seriously
affect its basic functioning and the safety that the
child seat provides.
16. The safety seat must remain installed in the
vehicle with the safety belt, even if the child is
not seated in the child seat. The child must never
be left unattended while seated in the safety seat,
not even outside the vehicle.
17. Keep the safety seat away from corrosive
products.
18. Do not use anchor points that are not listed in the
instruction manual and indicated on the seat.
19. The seat should be replaced after undergoing the
violent stresses associated with an accident.
20. The manufacturer guarantees the quality of
its products, but not the quality of second-
hand products or products belonging to other
companies.
21. Instruction illustrations are for informational
purposes only. The child restraint system may
contain small differences compared to the
photographs or images in the instruction manual.
These variations do not affect its certification
under ECE Regulation R44/04.
22. Ensure that any strap or belt that holds the child
is not bent or twisted and keeps tightened. Act
under the same criteria with the vehicle belts that
serve as a restraint for the chair.
1. OvERvIEW
(1)
Headrest
(9)
Headrest
(2)
Belt guide
height adjuster
(group 2/3)
(10)
Shoulder
(3)
Shoulder
straps
protectors
(11)
Abdominal belt
(4)
Cushion
guide (groups
0+/1/2/3)
(5)
Buckle latch
(12)
Base
(6)
Harness buckle
(13)
Harness
button
adjustment
button
(7)
Harness buckle
(14)
Harness
adjustment belt
(8)
Crotch pad
(15)
Reclining lever
(9)
Headrest
height
adjuster
(18)
Shoulder pads
strap connector
(16)
Diagonal
belt guide
(group
0+/1)
(11)
Abdominal belt
guide (groups
(17)
Harness
0+/1/2/3)
strap
connector
(21)
Isoclick Fix
®system
(19)
Isoclick Fix
unlock button
arms
35
Publicidad
Tabla de contenido
