Babyauto more WERDU RWF DS15 Manual De Instalación página 22

3. Make sure that the displayed arms corresponds to the
selected installation, group 0 (rearward facing) or group
1/2/3 (forward facing) (fig. 9).
* The insertion guides facilitate the installation of the
safety seat with the aid of the ISOFIX securing points
and prevents damage to the upholstery. When not in use
they should be removed and stored in a safe place. In
vehicles with a reclining back the insertion guides should
be removed before the seat is reclined. Problems that
may arise are generally the result of accumulation of dirt
or foreign bodies in the insertion guides and the clasps.
To solve this type of problem simply clean the part in
question.
5. Make sure the 5-point harness of the safety seat has
been correctly installed (see section 3).
6. Follow the steps described in section 3.7.
(12)
7. Recline the seat fully. Pull the lever
adjust the angle of recline to position 4 without releasing
the lever. Release the lever when the seat is in the desired
position (fig. 10).
8. Make sure the Isoclick Fix arms are displayed to install the
car seat backward facing (group 0+/1).
9. Place the seat in the back seat of the vehicle in opposite
direction of travel.
10. Hold the safety seat with both hands and insert the two
(19)
Isoclick Fix arms firmly into the insertion guides
until they fasten with a click on both sides. The red button
will partially change to green on both sides (fig. 11).
11. Shake the seat to check that it is correctly anchored to the
vehicle's ISOFIX points.
42
fig. 10
1 2 3 4
clIcK
fig. 11
forward and
fig. 12
(26)
• Uninstalling the Isoclick fix system
1. To free the Isoclick Fix anchoring, press the Isoclick Fix system
unlock buttons (21), in order to free the seat from the vehicle
ISOFIX anchoring system (fig. 12).
4.2 fastening the seat with the vehicle's belt in a rearward-
facing installation. Group 0+/1. (Optional)
1. Make sure the 5-point harness of the safety seat has been
correctly installed (see section 3).
2. Follow the steps described in section 3.7.
OK
3. Recline the seat fully. Pull the lever
angle of recline to position 4 without releasing the lever. Release
the lever when the seat is in the desired position (fig. 10).
4. Place the seat in the back seat of the vehicle in opposite
direction of travel (fig. 9).
5. Take out the reducer cushion (4). Pass the abdominal strap of
the seat belt through the lower seat guides
the seat. Buckle the vehicle seat belt until you hear a click (fig.
13).
6. Pass the abdominal strap of the seat through the upper guide
(16) as shown (fig. 14/A).
7. Take up the remaining slack of the diagonal section of the 3-point
seat belt (fig. 14). and make sure it is as tight fitting as possible.
Ensure the straps are not twisted or knotted at any point.
8. Place the reducer cushion in his original place.
9. Follow the steps in section 5, securing the child with the 5-point
harness.
fig. 13
(15) forward and adjust the
fig. 14/A
(11) and underneath
16
(16) Diagonal belt guide
(group 0+/1).
clIcK
fig. 14
43