Babyauto more WERDU RWF DS15 Manual De Instalación página 23

5. PlAcING ThE chIld IN ThE sEAT.
GROUP 0+/1
TIP: The more snugly the harness fits over the child's
body, the better the child will be protected. therefore
avoid putting thick clothes on your child under the belt.
(7)
1. Release the harness buckle (fig. 15).
2. Press the harness adjuster button (13)
pulling the part of the harness straps that cross
the chest in order to loosen them fig. 2). Do not
pull the shoulder protectors.
3. Place the child in the safety seat.
4. Make sure the child's back rests firmly against the
back of the safety seat.
(5)
5. Bring the two clasps together and join them
before inserting them into the harness buckle
You should hear a click (fig. 16).
(14)
6. Pull the harness adjustment strap in order to
tighten and adjust it correctly to the child's body (fig.
17).
IMPORTANT! The part of the harness straps that
crosses the abdomen should be placed as low as
possible on the child's hip.
7. Pull down on the shoulder protectors
ensure they are properly in place.
For the safety of the child the following checks
44
fig. 15 fig. 16
while
(14) Harness
adjust strap. fig. 17
(7) .
14
should be made before every trip:
• The safety seat is firmly installed in the vehicle.
• The straps are not twisted.
(3) to
• The safety seat straps are firmly fastened around
the child's body, without squashing it.
• The shoulder straps (10) are correctly adjusted
and not twisted.
• The shoulder protectors (3)
child's shoulders.
• The clasps (5) are correctly inserted into the belt
buckle (6).
6. cAR sEAT fORWARd-fAcING
INsTAllATION. GROUP 1 (OPTIONAl)
clIcK
GROUP 1 only. From 9 months to 4
years approx. (9 - 18 kg)
1. Ensure that the seat is not in number 4 reclined
position. Pull the lever
the angle of recline to position 1, 2, or 3 without
releasing the lever. Release the lever when the seat
is in the desired position (fig. 18).
WARNING! once the car seat is installed, if another
recline position is selected, you should repeat the
car seat installation steps described below to ensure
a proper installation s in this new position.
NOTICE: This car seat offers different installation
options (installation table, chapter 2) wITH or
wITHOUT Isoclick Fix® connectors.
• For a car seat installation using Isoclick Fix®
connectors and vehicle's belt, please start from
section 6.1.
• For a car seat installation using only the vehicle´s
belt, please start from section 6.2.
are on a level with the
1 2 3
fig. 20
(15)
forward and adjust
(11)
Abdominal
belt guides
(group
0+/1/2/3).
fig. 18 fig. 19
4
clIcK
OK
16
fig. 21
clIcK
11
11
45