3.7. Adjusting the harness and headrest height in
an installation with a 5-point harness. Groups
0+/1
Proper adjustment of the height of the harness
ensures the child will be seated correctly. The
harness should be adjusted to the height of the
child's shoulder or slightly above; never behind the
child's back or level with the ears (fig. 7).
IMPORTANT! The shoulder straps should not be
passed behind the child's back at or above ear level.
1. Loosen the harness straps by pulling them gently
while pressing the harness adjustment button
(fig. 2).
(9)
2. Pull the headrest height adjuster
headrest
(1)
at the same time. Select the correct
height for the shoulder straps
(10)
and fix them in
the correct position for the child by releasing the
adjuster (fig. 6).
3.8. Adjusting the headrest. Groups 2/3.
A correctly adjusted headrest ensures that the
diagonal part of the safety belt is ideally positioned,
offering the child the best possible protection.
The headrest should be adjusted so that a space
equivalent to two fingers remains between the
headrest and the child's shoulders.
To adjust the height of the headrest:
1. Pull the headrest height adjuster
(9)
headrest at the same time. This will unlock the
40
headrest (fig. 6).
2. Now you will be able to move the headrest to the
desired height. when the adjuster is released the
headrest will remain locked in the chosen position.
3. Place the safety seat on the car seat.
4. Sit the child in the seat and check the height. Repeat
the process until the correct height is achieved.
(13)
(9)
Headrest and
fig. 6
harness height
adjuster.
and the
fig. 7
and the
4. cAR sEAT REARWARd-fAcING
INsTAllATION. GROUP 0+/1
GROUP 0+/1. From 0 to 4 years
approx. (0 - 18 kg).
It is advisable to use the seat backward-
NOTICE:
facing as long as possible. If the height of the
child or the size of the vehicle prevents the child
to travel rearward-facing until 18kg, we advise
to maintain rearward-facing travel position up
to 13 kg. If necessary, the seat can be installed
forward-facing when the child reaches 9kg of
weight.
This car seat offers different installation
NOTICE:
options (installation table, chapter 2) wITH or
wITHOUT Isoclick Fix® connectors.
• For a car seat installation using Isoclick Fix®
connectors and vehicle's belt, please start from
section 4.1.
fig. 8
26
(26)
Latch guide
(25)
ISOFIX securing
point.
25
• For a car seat installation using only the vehicle´s
belt, please start from section 4.2.
4.1 connecting the Isoclick fix® arms in a
rearward-facing installation. Group 0+/1.
(optional)
• Preparing the Isoclick Fix system
1. If your vehicle has not been fitted with the ISOFIX
latch guides as standard, fit the two latch guides
(26)
that came with the safety seat.
* with the opening facing upwards at the two ISOFIX
securing points
(25)
of your vehicle (fig.8).
2. By turning, extract both Isoclick Fix arms
Move the arms from side to side until you hear the
click indicating that they are fully locked (fig 9).
(19)
Isoclick Fix®
arms.
A
Group 1/2/3
installation.
b
Group 0+/1
installation.
A
19
(19)
.
fig. 9
b
41