Adjusting The Throttle Cable - Stihl FS 300 Manual De Instrucciones

English
A
4
1
Place the handlebar (4) in the lower
N
clamp (1) so that distance A is no
more than 15 cm.
Place the upper clamp in position
N
and press it down.
Insert the clamping screw.
N
Line up the handlebar at a right
N
angle to the drive tube.
Tighten down the clamping screw
N
firmly.
60
8
7
5
6
Take out the screw (5), the nut (6)
N
remains in the control handle (7).
Push the control handle onto the
N
end of the handlebar (4) until the
holes (9) line up – the throttle
trigger (8) must point towards the
gearbox.
Insert the screw and tighten it down
N
firmly.
Go to "Adjusting the Throttle Cable".
N
Transport and storage position: Loosen
the clamping screw, turn the handlebar
in line with the drive tube and fold the
handles down.

Adjusting the Throttle Cable

It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
7
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
9
assembled.
4
9
Set the throttle trigger to the full
N
throttle position.
Carefully rotate the screw in the
N
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
FS 300, FS 350, FS 380