SATA AE1021 Manual Del Uso página 54

2.6 Erection of column
Remove the bolts at the installation position of the column on the chassis, place the column assembly on the chassis, and put the warning
label forward to align the holes on the bottom plate of the column with the screw holes on the chassis, and tighten with bolts again.
2.7 Installation of hexagon rod pressure spring
- Remove the screw on the pressure rod cap of the hexagon rod with a hexagon wrench. When removing the screw of the pressure rod
cap, the hexagon rod shaft must be locked with a locking handle to prevent falling and causing equipment damage or personal injury
accidents.
- Insert the pressure rod long spring into the pressure rod, reinstall the pressure rod cap and tighten it.
Pressure rod cap
54
AE1021/AE1021-3/AE1021H/AE1021H-3
Bolt
Locking cap
中文
EN DE RU KO
Pressure rod long spring
PT JA ES