arietta ALS436SS Guía De Instrucciones Para Instalación página 7

■ Remove the knockout and the Junction box cover and install
the conduit connector (cULus listed) in junction box.
■ If not already done, install ⁄
1
2
NOTE: This connector is not included with vent hood.
■ Run black (live), white (neutral), and green (earth) wires (#14 AWG)
according to the National Electrical Code or CSA Standards and local
codes and ordinances in ⁄ " conduit from power supply to j-box.
1
2
■ Connect black, white, and green wires from power supply to black,
white, and green/yellow wires in j-box respectively.
■ These connections should be done while always making reference to
the electrical diagram found inside the hood.
■ Close j-box cover and reapply.
If range hood does not operate:
■ Check that the circuit breaker is not tripped or the house fuse blown.
■ Disconnect power supply.
■ Check that wiring is correct.
Keep your Installation Instructions and Use and Care Guide close to
range hood for easy reference.
" conduit connector in j-box.
Mounting the duct cover
■ Position the duct cover over the mounted hood.
■ Slide the bottom of the duct into the glass area.
■ Position the top of the duct over the duct mounting bracket. If a
telescopic duct cover is used, grab the upper part of the
telescopic duct cover, pull it and place it in the duct cover
mounting bracket.
■ Secure the top of the duct with 2 assembly screws provided.
■ Secure the bottom of the duct with 2 assembly screws provided.
■ Install the grease filter and turn power on at service panel.
■ Check operation of the hood.
7